• Hobby Frank

Nitro Fury continued...

It's been a slow rainy Monday so time to continue work on the Nitro Fury... I left off at attaching the motor mounts to the engine the engine is placed in the hull and lined up with the prop shaft it should be aligned well enough that the shaft slips freely in the collet.

Then mark and drill the holes for mount screws as per the instructions!...

Before the engine is installed permanently the fuel tank must be assembled and put in the hull.

Install mount screws in holes, realign the engine and shaft with the mount screws loose... tighten fully when satisfied with the fit...

#proboat #nitroengine #radiocontrol

12 views0 comments

Recent Posts

See All